Things you need:
- 10W-30 SAE motor oil, DO NOT run synthetic, cast iron motors were not ment for it
- If it's been sitting for a while you are going to want to buy an extra 3-4 quarts but other wise you only need 5 quarts
- Oil filter, go to your nearest auto parts store and get the cheapest one, they are all the same, I'd prefer FRAM because thats what I use
- Drain pan
- Old rags
- Wrenches
- Underneath your truck is an oil pan
- You Take out the drain plug and let the oil drain into a pan
- Let it drain untill the oil slows to a drip then SNUG the drain plug when u tighten it, you don't wanna strip that
- Next to the oil pan is the oil filter, unscrew that and let the oil drain out
- Put the new filter in
- Top off the oil (5 Quarts-ish)
- Start it and let it run for a while
- Turn it of and drain the oil again
- You don't need to replace the filter
- Tighten drain plug and re-fill with oil
- Write down some where, preferably a sticker on your window, how much milage you have on your truck when you did the oil change PLUS 3,000 miles, because that's when you want to do it again
- Make sure you are at the full line with oil
- You're done :)
- Take it to your local dump, they sould have a facility for used motor oil
No comments:
Post a Comment