Putting in a starter

So i was letting my buddy borrow my truck, all of a sudden i get a call saying, "yeah, your truck won't start". So i book it over there and see what the problem was, (this is in a McDonalds parking lot). I crawled under the passanger side with a hammer and began pounding on the starter untill it started. Moral of the story is, i needed a new starter.

 

Tools you need:

• 16, 14, 8 and 9 millimeter sockets w/ wrench

Parts You Need:

• Basically you can take a starter off any small block chevy motor that is PRE-Vortech

Disassembly:

• Disconnect the negative battery cable




To the left of his hand is what you're looking for

• Crawl under the passenger side and take the 2 bolts off holding the starter up
• Then Disconnect the possitive battery cable from the starter and the controll wire
• Set it off to the side

Re-assembly:

• MAKE SURE the terminals are clean on the new starter
• Put the wires back on their corresponding terminals
• Tighten the nuts down
• Put the starter back in position and slide the bolts in
• Tighten them down
• Plug your battery back in
• Be on your merry way =)